'Inteligenty' dom ze sterownikiem PLC

Language:
Szukanie zaawansowane  

Aktualności:

Powrót do strony głównej: www.edom-plc.pl

Autor Wątek: PFC200: KNX Module  (Przeczytany 2091 razy)

domocla

  • Newbie
  • *
  • Wiadomości: 6
    • Zobacz profil
PFC200: KNX Module
« dnia: Września 14, 2017, 06:48:38 pm »
Hi there,
I am integrate KNX bus with a PFC. All the procedure is clear but I need a to clearify a doubt.

In case I would like to send always a bit telegram value a "0" and not a toggle how can do that? In the FB for a switch there is only a xSwitch_IN. If there's a rising edge of the signal wago send a "1" in KNX system and it send "0" when the signal goes low.

But I would like send always "0" to KNX bus. Could you help me please?

Thanks.

Zapisane